基本释义:

形板测验

网络释义

1)form board test,形板测验

2)FormBoard Test,形板测验

3)form board,形板

4)arc plank,弧形板

5)rectangular plate,矩形板

6)corrugated plates,波形板

7)sector plate C-276,扇形板C-276

8)webbed board,蹼形板

9)gauge and shape,板形板厚

10)segment,扇形板

用法和例句

Analysis of internal force of outer shaft lining of high strength reinforced concrete arc plank in deep frozen shaft;

深冻结井高强钢筋混凝土弧形板外壁内力分析

Three-dimensional analysis of thermo-mechanical-electric behaviour of functionally gradient piezoelectric material rectangular plate;

功能梯度压电矩形板热机电耦合三维分析

Dynamic response of rectangular plate on two-parameter foundation to moving load;

双参数地基矩形板在运动荷载下的动力响应分析

A general analytical solution of anisotropic rectangular plates in bending;

各向异性矩形板弯曲的一般解析解

The mixture of air and atomized water was used in the experiment instead of steam-water,the separating efficiency of three kind of corrugated plates(without hook,with single hook,with double hook) were measured respectively under various inlet velocity,and the dimensionless formula for predicting the.

为了深入研究波形板内的液滴分离和二次携带现象的机理,优化波形板结构,针对波形板汽-水分离器展开了冷态实验分析。

To optimize the design,the flow fields of different structures and spaces in the condition of cold and actual operation state of corrugated plates dryer are simulated by the fluent computation code.

采用FLUENT软件对波形板干燥器的5种波形板板型在3种不同板间距下的汽流场进行了模拟计算。

The integrated control of gauge and shape in hot strip mills is important and difficult.

针对热连轧过程中板形板厚综合控制问题,提出了兼顾板形的负荷分配方法,并且 使用免疫遗传算法进行了参数优化。

Finite element analysis for segment of leverplunger mandrel;

基于有限元分析的卷筒扇形板结构优化设计

Research into the thermal deformation of 1580 Hot Strip Coiler′s segments;

1580热连轧机卷取机卷筒扇形板热变形研究