基本释义:

增量负荷偏差

网络释义

1)incremental load deviation,增量负荷偏差

2)load gain,负荷增量

3)load ratio deflection,负荷率偏差

4)partial increment,偏差，偏增量

5)load increase,负荷增大，负荷增量

6)partial increment deviation,偏增量变差

用法和例句

For this status, this paper proposes a new load ratio deflection method for making monthly trade schedule of directly dispatched thermal power generation units.

针对此现状,提出了一种负荷率偏差法,用于解决直调火力发电单元月度电能交易计划编制问题。

Load ratio deflection method for making monthly trade schedule of directly dispatched thermal power generation units

编制直调火力发电单元月度电能交易计划的负荷率偏差法

The effect of mental loading on accuracy and bias of meta-memory monitoring

心理负荷对元记忆监测准确性及偏差的影响

PRODUCTION PRACTICE OF ENHANCING EQUILIBRIUM RATIO OF THE MINUS-DEVIATION ROLLING IN THE HOT ROLLED ANGLE

提高热轧角钢负偏差轧制均衡率的生产实践

RELATION BETWEEN THE VOLUME HEAT LOAD OF UPPER FURNACE AND THE FLUE GAS TEMPERATURE DIVIATION FOR TANGENTIAL FIRING BOILER

锅炉炉膛上部容积热负荷与煤粉锅炉烟温偏差的关系

Mean BP, heart rates, and BP loads were not different between daytime or nighttime.

平均血压、心率和血压负荷白天和夜间没有显著性差异。

Precise Large Deviations and Asymptotics of the Tail Probability for Sums of Negatively Associated Random Variables with Heavy Tails;

负相协重尾随机变量和的精致大偏差及尾概率的渐近性

Effection of the Peak Latency and Amplitude of Normal Group s Mismatch Negativity Change in Frequency Difference and Intensity Difference;

频率和强度的偏差程度对正常人错配负反应的影响

Load Factor The load factor is the ratio of the average load to the generator set power rating.

负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。

Automatic compensation load reactive power, enhancing the load power factor.

自动补偿负荷无功功率，提高负荷功率因数。

If we compensate the pump station with lower power numbers for electric power and electric capacity, we can reduce the current load in the power source and the lines.

对已建成的功率因数偏低的泵站采用电力电容补偿，可减少电源和线路的电流负荷。

It had a margin of error of plus or minus 3.2 percent.

其误差率在正负3.2%。

Operational Principle and Error Analysis Based on Strain Gauge Load Cell

负荷传感器工作原理与误差来源分析

The Fast Algorithm of Circular Arc Interpolatio with Negative Deviation Character;

具有负偏差特性的快速圆弧插补算法

Motor mounts are heavy duty design to minimize deflection and vibration.

电机是重负荷设计，达到最小的振动和偏斜。

Annual load forecasting based on grey model and Partial Least-Square method

基于灰色和偏最小二乘方法的年度负荷预测

Infrared measurement of the heat flux at the outer pertor target plate on the HL-2A tokamak

HL-2A装置偏滤器外靶板热负荷的红外测量

This method is called the loss-of-load probability (LOLP) method.

此方法称为负荷丢失概率(LOLP)法。

Studies of Driver s Physiological Loads Based on HRV;

基于心率变异的驾驶员生理负荷研究