基本释义:

轴承磨擦损耗

网络释义

1)bearing friction losses,轴承磨擦损耗

2)bearing friction loss,轴承摩擦损耗

3)abrasive wear,friction loss,磨擦损耗

4)loss of bearing,轴承损耗

5)wearing of bearing,轴承磨损

6)worn bearing,磨损轴承

用法和例句

The slope coefficient of loss of bearing-bearing capacity line may be used for estimation, the smaller the slope, the greater the bearing capacity, the smaller the loss.

轴承损耗-承载力线的斜率大小可用来判断止推轴承的性能。

Excessive friction in strut upper bearing

支柱上轴承磨损过度

electromagnetic bearing wear detector

电磁式轴承磨损探测器

Research on Mapping Model Between Wear Debris and Worn Surfaces in Sliding Bearings

滑动轴承磨损表面与磨粒信息映射模型研究

The great part among faults was serious wear of graphite bearing, or even cracked.

其中大部分故障是石墨轴承磨损严重,甚至开裂。

Use of the bearing oil leak detector will determine whether or not bearing wear has been uneven.

使用漏油检测装置即可判定轴承磨损是否均匀。

If the bearings show significant wear

如果轴承出现严重磨损

Bearings with modest hardness able to avoid axis wear.

软硬适中的轴承，有效防止轴心磨损。

Worn or defective transaxle gears or bearings

传动齿轮或轴承磨耗或损坏

renew worn tyres, bearings, brake-blocks, etc

更换磨损的轮胎、 轴承、 闸瓦等

The Reasons for Wear and Tear of Bearings in Deceleration Devices Used in Coal Mines and Relevant Countermeasure;

煤矿减速器轴承位磨损的原因及对策

Analysis of Fretting Wear and Fretting Protection for Wind Turbine Pitch Bearing

风力发电机变桨轴承微动磨损与防护

Research on the Wear Failure of Colliery Hoister Journal Bearing

煤矿提升机滑动轴承的磨损失效分析

"Such conditions as these will cause uneven bearing wear, with some bearings wearing faster (and more unevenly) than others. "

类似这样的情况会造成轴承不均匀磨损,而且一些轴承会比另一些磨损得更快。

The failure of the hollow cylinder roller bearing is stress corrosion wearing.

空心圆柱滚子轴承为应力腐蚀磨损失效。

Corroding and Wearing of Slide Bearing in Agitator for Storage Tank ?and the Relevant Counter Measurement

浆池搅拌器滑动轴承的腐蚀、磨损及其对策

Study on Friction and Wear Property and Lubricant Mechanism of Water Lubricated Bearing;

水润滑轴承的摩擦磨损性能及润滑机理的研究

Preparation and Tribological Behavior of a Heavily Loaded 40Cr-PTFE Composite Bearings;

40Cr-PTFE重载复合材料轴承的制备及摩擦磨损特性

Study on formation and precaution of grinding thermal damage to bearing rings

轴承套圈磨削热损伤的形成与预防探讨