基本释义:

轴向位置

网络释义

1)axial position,轴向位置

2)relative axial position,轴向相对位置

3)axial position indicator,轴向位置指示器

4)axial thrust failure protective device,轴向位移保?装置

5)Ejector axial position,引射器轴向位置

6)axial location of fuel nozzle,燃油喷嘴轴向位置

用法和例句

Influences of axial positions of grooved casing treatment on stall margin improvement;

轴向位置变化对槽式机匣扩稳效果的影响

The effects of the relative axial position between mandril and external die on cold drawing internal rifled tubes is analyzed.

本文借助于有限元分析软件Marc对冷拔内螺旋凸筋管进行了有限元模拟,分析了芯棒与凹模的轴向相对位置对冷拔内螺旋凸筋管成型的影响。

Effect of ejector axial position on performance of pulse detonation engine

引射器轴向位置对PDE的性能影响实验

Error Analysis of Axial Position and Measuring Equipment Design for NC Machine Tool

数控机床轴向位置误差分析及测量装置设计

The influence of rotational speed and axial location(six locations) was summarized.

研究了不同转速下不同轴向位置（6个轴向位置）时旋转盘腔内部流场的分布规律。

Supplies the required 5 volt power source to the crankshaft position sensor, camshaft position sensor, MAP sensor and throttle position sensor.

向曲轴位置感应器、凸轮轴位置感应器、MAP感应器以及节气阀位置感应器提供所需的5伏电压。

a function that changes the position or direction of the axes of a coordinate system.

改变一个坐标系统的轴的方向或位置的函数。

Reason Analysis about the Position Where a Invalidating Section on Cast Iron is Caused by Compression along an Axes;

铸铁材料受轴向压缩失效截面位置及原因分析

Realizing Spindle Random Location Orientation Function Using FANUC NC System

用FANUC数控系统实现主轴任意位置的定向功能

A movement from and back to a mean position or axis in an oscillating or alternating motion.

移动从中间位置或轴线向外或向后的振荡或依次的运动

The maximum amount of oil is reached when marker dot A is brought to the position just opposite from the needle bar crank 3 by turning the adjust pin in direction C.

从图上所示的位置向C方向转动，当转到与针杆曲轴3的正对面的位置时，油量为最大。

POSITION SENSOR PRINCIPLE AND AXIAL EXCITING COIL EMF OF AXIAL AND RACIAL AIR GAP HYBRID MAGNET CIRCUIT MULTI-COUPLING MOTOR

轴径向气隙混合磁路多边耦合电机轴向励磁绕组的反电势及其位置传感器机理

cam shaft reversing lock

凸轮轴换向闭锁装置

axial piston transmission

轴向柱塞式传动装置

Create a Position Key on

创建Y轴位置关键帧

Create a Position Key on X

创建X轴位置关键帧

Create a Position Key on Z

创建Z轴位置关键帧

Delete a Position Key on

在Y轴删除位置关键帧

Delete a Position Key on Z

在Z轴删除位置关键帧

Delete a Position Key on X

在X轴删除位置关键帧