基本释义:

油工作温度

网络释义

1)oil operating temperature,油工作温度

2)hydraulic oil operating temperature,液压油工作温度

3)working oil temperature,工作油温

4)Working Temperature,工作温度

5)operating temperature,工作温度

6)operation temperature,工作温度

用法和例句

Working oil system is the key part in variable speed turbo coupling,while the problem of working oil temperature does harm to running of variable speed turbo coupling sometimes.

工作油系统是液力耦合器的关键环节,而工作油温问题时常影响液力耦合器的正常使用。

are equipped with 2 kinds of governor hydraulic coupler with different structure,this article compares the characteristics of working oil temperature of the two kinds of governor hydraulic coupler by analyzing the slip loss and the working oil circuit,and discussed the perse problems appeared in the operation of the governor hydraulic coupler.

文章通过对调速型液力耦合器的滑差损失和工作油回路进行分析,比较了这两种不同结构液力耦合器的工作油温特性。

Valve working temperature is grade under 425 ℃;

对阀门工作温度在425℃以下温度分级的建议

The practical technology to control the heat pipe working temperature was introduced based on the heat transfer principle.

根据传热学原理,给出了控制热管工作温度的工程实用技术;针对油田加热炉改造问题,提出以热管流动阻力最小为目标函数的一种优化设计思想,用以限制烟气的流动阻力。

The working temperature of sand cores for aluminum casting have been tested in the present work.

对铝合金铸造用砂芯的工作温度进行了分析和测定。

Study on operating temperature of high-speed cylindrical roller bearings;

高速圆柱滚子轴承工作温度研究

Influence of operating temperature (T=25℃, 35℃, 45℃, 55℃) on the electrochemical performance of V-based solid solution type hydrogen storage alloy TiV_(2.

系统研究了工作温度(T=25,35,45,55℃)对V基固溶体型贮氢合金TiV_(2。

As the operating temperature rises from 25 ℃ to 60 ℃, hydrogen equilibrium pressure of the alloy increases from 0.

针对电动车用大型动力 Ni/ MH电池工作温度较高的特点 ,系统地研究了 3种工作温度 (2 5℃ ,40℃和 6 0℃ )对贮氢合金 RENi3。

The operation temperature is an effective factor on charge - discharge performance of large capacity Ni-MH battery.

工作温度是影响大容量MH-Ni电池充放电性能的重要因素。

08) sintered magnet materials were prepared by common powder metallurgy process, and the effect of Cu addition was investigated on the intrinsic coercivity and its temperature dependence, and consequently on the operation temperature of the magnet.

08)材料,研究了Cu含量对材料内禀矫顽力及其温度系数的影响,进而探讨了Cu含量对材料工作温度的影响。

Study and Practice of Characteristics of Working Oil Temperature in Variable Speed Turbo Coupling

调速型液力耦合器工作油温特性分析与应用

Reason analysis and improvement of high working oil temperature of hydraulic coupling in induced draft fan and pipe vibration

引风机液力偶合器工作油温高和管路振动原因分析及治理

The Effect of Ambient Temperature in Wells on Function Safety of Pyrotechnics

油井环境温度对火工品作用安全性的影响

Research on Control of Work Process and Emission of Diesel Engine under Cold Conditions

柴油机缸内工作过程及低温运行排放控制研究

The oil must have a sufficiently high viscosity at high operating temperatures to ensure the formation of a continuous film of oil between the bearing and shaft.

润滑油在较高的工作温度下必须具有足够高的粘度，以确保轴承和轴之间形成连续的油膜.

A colorless, flammable liquid, C6H14, derived from the fractional distillation of petroleum and used as a solvent and as a working fluid in low-temperature thermometers.

已烷一种无色可燃液体，C6H14，从石油的分馏中提取，用作溶剂和低温度气压计中的工作流体

High and low temperature test technology of kerosene of the LOX/kerosene engine

液氧/煤油发动机煤油高低温试验工艺技术

Soaking-pressing Production Technology of Almond Oil Using Hydraulic Oil Press

液压榨油机低温浸榨杏仁油的工艺研究

Technical code for insulation for petroleum engineering in beach-shallow sea

滩海石油工程保温技术规范

The High-Temp Resistant Carbon Fiber Reinforced Plastic Continuous Sucker Rod Produced by Pultrusion Process;

耐高温碳纤维抽油杆工艺与性能研究

Quality Control of Anti-corrosion and Heat-preservation Project in Long Distance Crude Oil Pipeline;

原油长输管线防腐保温工程质量控制

Non-heating Transportation Technology of Crude Oil Applied in Gangdong Oilfield

自然常温输送工艺在港东油田的应用

Investigation on supersonic combustion of kerosene using fuel-rich hot gas as pilot flame

高温富油燃气作引导火焰的煤油超燃研究

The Analysis and Research for the 72000DWT Crude Oil Tanker Heating and Insulation Process Operation System

72000吨油轮货油加热保温操作系统开发研究

bubble memory operation temperature

磁泡存储器工作温度

Test at operating temperaturCold engine, tight (new) engine, or heavy oil will increase starter amperage draw.

在工作温度时测试。冷引擎，紧的（新的）引擎，或重油将增加启动马达的耗电量。

Exhaust air cooling down when passing through the hood,it provides a cold and pleasant working environment to the chefs.

排出的油污及热空气,因其经过洒水系统部份,以致排出空气减温,徒而提供一个较清闵工作环境.

High efficiency liquid cooling system for optimum engine operating temperature- includes compact liquid cooled oil cooler.

高效率的液冷却系统为引擎提供了最佳的工作温度—他甚至还包含了一个紧凑的机油冷却器。