基本释义:

主轴承油槽

网络释义

1)main bearing oil gallery,主轴承油槽

2)bearing oil sump,轴承油槽

3)multiple groove bearing,多油槽轴承

4)main-bearing oil seal,主轴承油封

5)main bearing oil pipe,主轴承油管

6)crosshead bearing oil groove,十字头轴承油槽

用法和例句

Oil may be forced out through the timing cover and rear-main bearing oil seals.

机油会从正时齿轮盖和后主轴承油封处压出。

main drive gear bearing oil slinger

主动齿轮轴承抛油环

Transformation of Axis Seal and Oil Files of N 25-35-1 Gas Turbine;

N25-35-1型汽轮机组高低压轴封轴承油档改造

Shaft Assembly (Male, female, washer, grease….

轴组件（轴，轴套，轴承，油脂。。。）

Replacement inside the Tunnel and Failure Analysis of Sealing of TBM Main Bearing

TBM主轴承内密封洞内更换及失效分析

In-the-hole Repair Technique for Main Shaft Lip Seal on TBM

TBM主轴承唇形密封洞内修复技术

Intunnel vestoration and airproof fault diagnosis in TBM main bearing

TBM主轴承内密封故障诊断与洞内修复

Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;

柴油机曲轴轴系强度和主轴承润滑仿真研究

A Study on the Seal of HAGC Cylinder and Oil Film Bearing of Backup Roll

HAGC油缸和支承辊油膜轴承用密封件的国产化研究

The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.

下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。

Install the new upper rear bearing oil seal with the white paint facing towards the rear of the engine.

安装新的上后轴承油封，使白漆面向引擎后部。

The dynamically balanced rotor assembly,sealed bearings with grease reserviors.

动平衡的转子总成，具有蓄油装置的全密封轴承。

spindle inner oil seal

(平衡器) 轴内油封

Study on Load Analysis Method for Diesel Engine Crankshaft Main Bearing Based on ADAMS;

基于ADMAS的柴油机曲轴主轴承载荷分析方法研究

Experimental Research on Oil-Air Two Phase Lubrication of High Speed Motorized Spindle Rolling Bearing;

高速电主轴滚动轴承油气两相流润滑试验研究

Study on Lubricating Characteristics of Crankshaft Main Bearing for High-duty Diesel

高强化柴油机曲轴主轴承润滑特性研究

Influence of oil temperature on lubricating performance for main bearing

机油温度对主轴颈轴承润滑性能的影响

Application of Oil Gas Lubrication Technique to Bearing of High-Speed Motorized Spindle

油气润滑技术在高速电主轴轴承上的应用