基本释义:

转向节轴[支]承

网络释义

1)steering knuckle bearing,转向节轴[支]承

2)Steering knuckle bearing,转向节轴承

3)steering knuckle thrust bearing,转向节止推轴承

4)knuckle bearing preload,转向节轴承预加负荷

5)steering knuckle thrust bearing,转向关节主动轴承

6)knuckle spindle,转向节轴

用法和例句

steering knuckle bearing grease nipple

润滑转向节轴承油嘴

Research and Development of a Real-Time Quality Monitoring System for Assembling Steering Knuckle Bearing

转向节轴承装配质量实时监控系统的研究与开发

"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."

当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。

Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.

大多数轴承都支承径向或轴向负荷的转轴。

tube and ball type steering column

球轴承套管式转向管柱

steering worm sector bearing

转向器扇形蜗轮轴承

Steering Knuckle Separation From Driveshaft

转向关节与驱动轴分离

The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing assembly.

更换轮毂及轴承组件内的车轮固定螺桩无需自转向关节中取出轮毂及轴承组件。

During steering maneuvers, the strut and the steering knuckle (through the ball joint and a pivot bearing in the strut's upper retainer) turn as an assembly.

车辆转向时，支柱以及转向关节（经由球形接头与上支柱固定器之轮毂轴承）会一体旋转。

" Spherical plain radial bearings, joint type-Redial internal clearance"

GB/T12278-1990向心关节轴承径向游隙

"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."

主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。

Radial Measurement on the Axial Displacement of AMB Rotor;

电磁轴承转子轴向位移的径向测量研究

" Spherical plain radial bearings, joint type-Boundary dimensions"

GB/T9163-1990向心关节轴承外形尺寸

The main components of a spider cardan joint include the spider, yokes and quill bearings, etc.

其主要部件包括十字轴、向节叉以及滚针轴承等。

Research of Spindle Radial Force on Bearingless Permanent Magnetic Motor

无轴承永磁电机转子径向力实验研究

"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."

万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。

The two-section propeller is supported by a center bearing and coupled together by universal joints.

两段传动轴之间有一个中间支承轴承,并由万向节连接。

The lateral vibration of a rotor/ bearing system influenced by axial contact between disk and stator are investigated by numerical simulation.

研究轴向摩擦对单跨双盘转子—轴承系统横向振动的影响。