基本释义:

左流量阀门

网络释义

1)left flow gate,左流量阀门

2)valve discharge characteristic,阀门流量

3)flow gate,流量阀门

4)constant flow vavle,恒流量阀门

5)flow gate adjustment,流量阀门调整

6)flow gate control,流量阀门控制

用法和例句

Noise Silencer for Steam Evacuation and Flow Adaptation of Its Valve in Thermal Power Plant

火电厂蒸汽放空消声器及其阀门流量适配

System of Measuring Coefficient of Valve Flow Based on Virtual Instrument;

基于虚拟仪器的阀门流量系数测试系统

Also, the valves may be damaged by the high velocity across the seats.

此外，通过阀座的高流量还可能损坏阀门。

Analyze the relationship between flow, pressure, pressure differential and valve opening of pressure reducing valves.

分析了减压阀的流量、力、力差和阀门开度的关系。

The trim valves of the confirming flow test.

应该确认这些阀门通过流量测试。

This valve regulates the flow of water.

这个阀门控制着水的流量.

A valve that regulates the flow of a fluid, such as the valve in an internal - combustion engine that controls the amount of vaporized fuel entering the cylinders.

节流阀调整流体流动的阀门，如内燃机中控制蒸汽燃料进入汽缸的量的阀门

Use, detected valves pressure reduction and read out the degrees, can be considered by the flow valves.

使用时，测得阀门压降和读出开度，即可算得通过阀门的流量。

Circuit Balancing Valves may be packaged with the balance of the NIBCO Commercial/Mechanical Valve line.

流量平衡阀可被用于平衡美国尼伯科的商用/机械式阀门管道。

Measure and record the differential pressure across the valve in the throttled position.

测量和记录通过处于节流位置的阀门的压差。

The flow coefficient (Cv) listed in the tables apply to fully open valves only.

表中所列流量系数仅适用于全开状态下的阀门。

Valve shall have integral metering/test ports for flow balancing and flow measurement.

阀门应该配置用于流量平衡和流量测量的整体测试端口。

"Valves,push button-24V,DC. "

24V,直流按钮操作的阀门

flow control and overload relief valve

流量控制过载溢流阀

a pedal that controls the throttle valve.

控制节流阀流量的杠杆。

Ensure that valve is installed in proper flow direction. Refer to flow direction arrow on valve nameplate or body.

确保阀门按照正确的流向安装。参照阀门铭牌或阀体上的流向箭头。

If flow rate is in excess of that specified, turn indicator towards closed position, noting pressure drop and valve setting and determining new flow rates from flow rate chart.

如果流量超过规定，将指示器旋转到关闭位置，注意压降和阀门设置，并从流量表中确定新的流量。

Before installation, check line of flow through valve so that valve will function properly.

安装前，切断通过阀门的流体，以使阀门工作正常。