基本释义:

左轴承[支承]

网络释义

1)left hand bearing,左轴承[支承]

2)bearing carrier,轴承支承

3)supporting bearing,支承轴承

4)backup bearing,支承辊轴承

5)bearing support tube,轴承支承管

6)bearing strip,轴承支承带

用法和例句

In order to improve the service life of backup bearing in four high rolling mill, the profitable experiments are carried on by improving the bearing structural design, strengthening seal, changing the working period of the roll and repairing the bearing to utilization.

为提高四辊轧机支承辊轴承使用寿命,从改进轴承结构设计、加强密封、改变换辊周期、轴承修复再利用等方面进行了有益的尝试。

Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;

交流磁轴承支承电主轴转子系统建模

Optimization Design of Active Magnetic Bearing Stiffness Based on ANSYS

基于ANSYS的电磁轴承支承刚度优化

Active Control on Vibration of Multi-Disc Flexible Rotor System Mounted on Magnetic Bearing;

磁力轴承支承的多盘柔性转子系统主动控制

Simulation and Analysis of Dynamic Behaviors of a Rolling Bearing-rotor System

滚动轴承支承的转子系统动力学仿真与分析

pto bearing support

动力输出轴支持轴承

Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.

大多数轴承都支承径向或轴向负荷的转轴。

Excessive friction in strut upper bearing

支柱上轴承磨损过度

The carriage is supported on guide shafts.

托架支承在导轴上。

In order to represent this behaviour, we can consider one of the supports to be a pin support and all the others to be roller supports.

为阐明这一特点，设梁的支承之一为销轴支承，其他均为辊轴支承。

rubber vibration isolators for journal bearing thrust bearers of railway rolling stock

铁路车辆车轴轴承推力支承用振动隔绝橡胶

Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;

长轴深井泵轴承支架水力参数的探讨

Design and Dynamic Analysis for Multi-Support Rotor-Bearing System Bearing Load Identification Test-Bed;

多支承转子—轴承系统轴承负荷辨识试验台设计及其动力学分析

All bearings are rolling bearings and the shafts are made of alloy steel.

轴支承全部采用滚子轴承。轴材料均为合金钢。链条均为强制润滑。

plain bearing housing with bearings

装有轴承的普通轴承座

housing bearing plain without bearings

未装轴承的普通轴承座

radial Bearing and thrust Bearing

横力轴承与推力轴承

cageless bearing

无保持架轴承,开口轴承

All bearings are on immovable supports at the same elevation.

全部轴承都位于同样高度不可动的支承上。