基本释义:

若大于或等于则分支

网络释义

1)BGE Branch if Greater or Equal,若大于或等于则分支

2)BLE Branch if Less or Equual,若小于或等于则分支

3)greater than or equal to,大于或等于

4)JGE Jump if Greater or Equal,大于或等于则转移〖指令〗

5)NGE Not Greater or Equal,不大于或等于

6)JNAE Jump if Not Above or Equal,不大于或等于则转移〖指令〗

用法和例句

Equal to, Not equal to, Less than, Greater than, Less than or equal to, Greater than or equal to

等于, 不等于, 小于, 大于, 小于或等于, 大于或等于

Enter a maximum value that is greater than or equal to the minimum value.

输入的最大值应大于或等于最小值。

The extinction timeout must be equal to or greather than the renew interval.

停止超时必须大于或等于续定间隔。

Time out should be greater than or equal to interval.

超时时间应该大于或等于时间间隔。

Registry subkeys should not be greater than or equal to 255 characters.

注册表子项不应大于或等于 255 个字符。

On the Numbers,k Multiples of which Equals or Exceeds the Sum and Its Proper Divisors;

关于某些真因子和大于或等于自身k倍的数

The minimum retention value cannot be greater than or equal to the maximum retention value.

最小保留值不能大于或等于最大保留值。

You must enter an update retry interval greater than or equal to 0.

输入的更新重试间隔必须大于或等于 0。

The lockout duration must be greater than or equal to the reset count time.

关闭期限必须大于或等于复位计数器时间。

Hours per week must be greater than or equal to hours per day.

每周小时数必须大于或等于每天小时数。

Invalid row values. Make sure the last row is greater than or equal to the first row.

行值无效。确保末行值必须大于或等于首行值。

You must enter an update timeout interval greater than or equal to 0.

输入的更新超时间隔必须大于或等于 0。

Index (zero based) must be greater than or equal to zero and less than the size of the argument list.

索引（从零开始）必须大于或等于零，且小于参数列表的大小。

You may assume that each integer is even, and is greater than or equal to4 and less than2^15.

假设每个整数为偶数，并且大于或等于4，小于2的15次方。

The value for Row Limit must be equal to or greater than zero and less than 4294967296.

“行限制”的值必须等于或大于零，并小于 4294967296。

Spirit dissemination is different from public dissemination and social dissemination.

精神传播不等于大众传播或社会传播。

The roundness tolerance equals to the difference between max. and min. outer diam. obtained by measuring at3 or more equable parts.

②圆度公差等于三等分或多等分测量所取得的最大或最小外径之差。

The roundness tolerance equals to the difference between max.and min. outer diam.obtained by measuring at 3 or more equable parts.

圆度公差等于三等分或多等分测量所取得的最大或最小外径之差。