基本释义:

冷轧钢丝

网络释义

1)cold rolled steel wire,冷轧钢丝

2)cold rolled screw,冷轧丝杆

3)rolled wire,轧制钢丝

4)cold-rolled steel sheet,冷轧钢板

5)cold-rolled strip,冷轧钢卷

6)cold rolled strip,冷轧钢带

用法和例句

In practical production,because wire rods had some defects,so break occurred in Y type wire cold rolling mill in the course of rolling The reasons of break of cold rolled steel wire have been analyzed Some requirements on structure,nature of material etc of wire rods have been put forwar

Ｙ型冷轧钢丝机组在实际生产中由于盘条存在着某些缺陷，在轧制过程中发生断裂。

Spherical annealing structure of 45 steel used for cold rolled screw,compared with nomalizing,can improve the rolling performance,the rolling quality and the roller’s service life.

冷轧丝杆所用 45钢 ,采用球化退火组织比正火组织轧制性能好 ,轧制件质量好 ,轧辊寿命长。

The corrosion resistance of cold-rolled steel sheet was studied by electrochemical tests including linear polarization(LP)and electrochemical impedance spectroscopy(EIS).

采用线性极化、电化学交流阻抗等方法研究了冷轧钢板的耐蚀性能,同时使用线性扫描伏安法获得了冷轧钢板表面氧化物的种类及还原电位,分析了其与冷轧钢板耐蚀性能之间的关系。

An effective coupling FEA model was established to compute temperature and heat stress, which is the main reason causing sticking problem of cold-rolled strip during annealing.

针对冷轧钢卷退火过程中引起粘结的主要原因-高温和压力,建立有效的计算模型,并根据实验给出的经验公式和实际工作状况,确定钢卷的边界条件和相应的物理参数。

Continuously electrolytic zinc-coated cold-rolled steel sheets and strips

GB/T15675-1995连续电镀锌冷轧钢板及钢带

Comparison of the Properties of 2205 Duplex Stainless Steel Cold Rolled Plates

国内外2205双相不锈钢冷轧钢板的性能比较

Cold rolled stainless steel clad sheets and strips

GB/T17102-1997不锈复合钢冷轧薄钢板和钢带

Cold rolled sheets and strips for civil enameling

GB/T13790-1992日用搪瓷用冷轧薄钢板和钢带

Cold rolled sheets and strips for deep drawing

GB/T5213-1985深冲压用冷轧薄钢板和钢带

Study on Monitoring Tactic for the Plate Thickness and Crown of Cold Rolling Strip;

冷轧带钢板厚、板凸度监测策略的研究

The Cold Steel Plate Ridging Analysis and Process Improvement of SUS444

SUS444不锈钢冷轧板板纹分析及工艺改进

Analysis on the Rusty Spots on the Cold-rolled Strip in Baotou Steel

包钢冷轧板板面锈斑产生原因及改进

Texture Evolution during Annealing in Warm Rolled and Cold Rolled Ti-IF Steel

冷轧后退火过程中温轧Ti-IF钢板织构的演变

The Practice for Production of Sheet Steel of Automobile with Compact Strip Production Hot Strips

以CSP热轧板为原料汽车冲压用冷轧钢生产实践

A Brief Introduction to the Compiling of Acid Rolling Plan Regarding MES System Applied in Tangshan Iron and Steel Group Strip Cold Rolling Plant

简析唐钢冷轧薄板厂MES系统酸轧计划的编制

Influence of the Precipitation of Dissolved Elements in the Hot Rolled Steel Band on the Cold Rolled Texture

热轧钢板固溶元素析出对冷轧织构的影响

Cold-rolled quality carbon structural steel sheets and strips

GB/T13237-1991优质碳素结构钢冷轧薄钢板和钢带

Study on Effects of Cold Rolling-Process on Microstructure and Properties of Nb+Ti- Interstitial Free Steel;

Nb+Ti-IF钢薄板冷轧工艺及组织性能研究

Research of Batch Annealing Process for Cold Rolled Adding P High Strength IF Steel Plate

加磷高强IF钢冷轧板罩式退火工艺研究

The Effect of Carbon Content on Properties of IF Steel

碳含量对IF钢冷轧板力学性能影响分析

Design Characteristics of Continuous Annealing Line for Cold-rolled Steel Sheet of Maanshan Iron & Steel Co.,Ltd

马钢2130mm冷轧薄板连续退火线设计特点

Recrystallization and Structure of Microalloyed High Strength Steel Sheet After Cold Rolling

冷轧高强度汽车钢板的再结晶及组织