基本释义:

受压木构件容许长细比

网络释义

1)allowable slenderness ratio of timber compression member,受压木构件容许长细比

2)allowable slenderness ratio of steel member,钢构件容许长细比

3)allowable value of deflection of timber bending member,受弯木构件挠度容许值

4)allowable specific pressure,容许比压

5)compression member,受压构件

6)compressed member,受压构件

用法和例句

Physics and mechanics performance of paste-like backfill material in coal mine such as strength,allowable specific pressure and compressive rate was researched by experiment.

通过实验研究了煤矿似膏体充填体的强度、容许比压、压缩率等物理力学性能。

Based on the analysis of distribution of pressure applied by hydraulic support base on seam floor, a method to test the allowable specific pressure of high water content material was suggested.

在分析回采工作面支架底座作用在底板岩层上压力分布特征的基础上 ,选择正方体试件用钢质小圆柱加压实验的方法测定高水速凝材料容许比压 。

Non-linear analysis of fire resistance of RC compression members;

钢筋混凝土受压构件防火性能的非线性分析

Based on the plane section assumption and the formulas of compression members with small eccentricity,the interaction diagram of ξ and the linear interpolation formula of ξ according to the calculation of rectangular section capacity with symmetrical reinforcement are presented.

根据平截面假定和小偏心受压构件的基本公式,提出了两种钢筋混凝土矩形截面小偏心受压构件对称配筋的简化计算方法,并应用两个相关实例进行验证,具有良好的效果,为今后设计计算改进和提高提供了依据。

The computing formula about the lateral deflection f and its corresponding coefficient η to the arbitrary cross-sections of the compressed member under different ending moments and constraint conditions are obtained.

针对现行规范中受压构件偏心距增大系数η的计算公式在应用方面存在的某些不足,采用有限元迭代法并考虑二阶弯矩的影响,得出在不同端弯矩和约束条件下偏心受压构件任意截面处侧向挠度f与相应的η计算公式。

Behavior of high strength steel columns under axial compression

高强度钢材轴心受压构件的受力性能

Structural Response of Stainless Steel Oval Hollow Section Compression Members

不锈钢椭圆中空受压构件的结构响应

Research on Behavior of Compressed Member Based on Concrete Mechanics;

基于混凝土力学的受压构件性能研究

Research on the Nonlinear Stability of Aluminum Alloy Axial Compression Members;

铝合金轴心受压构件非线性稳定研究

Study on the Experiment of Axially Stressed Structures of split T-Typed Steel

剖分T型钢轴心受压构件的试验研究

Experimental Research of the Concrete Filled Steel Tube Column Subjected to Axial Compress;

钢管混凝土轴心受压构件受力性能的试验研究

The Research on Bearing Performance of Corroded Reinforced Compressive Concrete Members;

锈蚀钢筋混凝土受压构件受力性能研究

A Precise Algorithm for the Relative Depth of Compressive Zone about The Compression Member with Small Eccentricity in Bridge Engineering

桥梁工程中小偏心受压构件相对受压区高度的精确计算方法

The circle section is rather reasonable for axial compressed member.

在轴向受压构件中,用圆形截面也是合理的。

Experimental Research on Uniaxial Compressing Structure Member with Composite Strengthening;

钢筋混凝土轴心受压构件复合加固的试验研究

Research on Stability for Axially Compressed Hot-Rolled Single--Angle Members;

热轧单角钢轴心受压构件整体稳定性能研究

Finite Element Analysis on Strengthening Compression Columns by Pre-stress;

预应力法加固混凝土受压构件有限元分析

The Experimental Study on Strengthening Axial Compression Columns by Prestressing;

预应力法加固混凝土轴心受压构件试验研究

Study on Dynamic Buckling of Axial Compression Member under Impact Load

冲击荷载作用下轴心受压构件动力屈曲研究

An Experimental Research on Hysteretic Behavior of Recycled Concrete Compression Member

再生混凝土受压构件滞回性能试验研究

BEHAVIOUR OF HIGH-PERFORMANCE CONCRETE FILLED STEEL TUBULAR COLUMNS SUBJECTED TO ECCENTRIC LOADING

钢管高性能混凝土偏心受压构件力学性能研究

STUDY ON THE STABILITY DESIGN METHOD OF HIGH STRENGTH STEEL ANGLE MEMBERS UNDER AXIAL COMPRESSION

高强度角钢轴心受压构件稳定设计方法研究

DISCUSSION ON COMPUTATIONAL NORMAL SECTION STRENGTHENING OF AXIAL COMPRESSION MEMBERS

轴心受压构件正截面加固计算方法探讨